Our Brau EZboil electric brewery controller is packed with features to make your brew day run on time and with perfect temperature control.
It is the perfect solution for a BIAB (Brew in a Bag) or single vessel brewery. Of course, you can also use the EZboil controller with a traditional 3 vessel brewing setup.
This controller is perfect for any element up to 6000W 240V. Comes with a 10' power cord and a 14-30P plug which is compatible with a standard 4 wire dryer receptacle. We can custom wire the controller with a Nema 10-30P plug, and even L6-30P. Keep in mind that to wire up the L6-30P the 'Aux' outlet on the controller will be 240V.
Buy it on it's own, or with our brewing element. Element power cord with a Nema L6-30 receptacle is included.
The EZ-Boil from Auber Instruments is our new favourite temperature regulating device. It is so simple to use, you can start brewing in minutes. A single knob on the front face helps you to dial in your mash temperature and set your mash timer. It comes with a built in alarm to let you know when mash is done, and it can be programmed to easily prevent an overshoot in your mash temperature. Easily switch between Mash and Boil mode. In Boil mode, the controller smoothly controls the boil, (unlike a PID) and can easily be set to alarm you before a boil over happens, plus it automatically dials down the power output at a pre-set temperature before a messy boil over ruins your brew day. While we love the precision that a PID offers, we found that the challenges of perfecting temperatures, and the learning curve of a PID wasn't for everyone. This controller takes all your frustrations away, and maintains within 1 degree of precision which is plenty precise to perfect your brew.
Included is our very own water tight 304 stainless steel Class A RTD PT-100 sensor. Our sensor comes with a braided stainless coated 6' cable with quick disconnects at the panel and at the probe.
Your choice of sensor:
1.5" tip with a 1/4" MPT thread.
2.35" tip with a 1/2" MPT thread.
3" tip with a 1/2" MPT thread.
1.35" tip mounted to a 1.5" Tri-Clamp flange.
For your safety around liquids we strongly recommend plugging this device into a GFCI protected circuit only!
Download the Auber EZBoil Quick Start guide here.
Download the Auber EZboil manual here.
1 year for the controller and 90 days for the sensor.